News: 01/28/13: A new minor release of AIM2000 is available for all customers. Download the password protected zip-file and send us ([email protected]) your serial number and the name of the buyer. Afterwards we will send you the password and the installation instructions. Here is the step-by-step instruction on programming GM (General Motors) ECUs with and SPS (Service Programming System) application in. NOTE: Before using the SPS, make sure that the Tech 2 scan tool and the pc contain the latest software, the battery of the vehicle is fully charged, only the ignition is on power, and all cables are connected properly. TIS2000 will not work on 2007 up GM, and software must work together with TIS2000 USB key. If you need to program Saab ECU, you had to use and USB dongle. Main steps: Step 1: Instruction for TIS2000 software Step 2: Data request Step 3: Data exchange Step 4: Program ECU Alternative Programming with “Pass Thru” Check Programming result Step 1: Instruction for TIS2000 software 1.Connect the Tech II to the pc. Note: The hardware key (HWK) has to be registered prior to working with ‘Service Programming System’. To register a hardware key, the form that is enclosed with the hardware key kit has to be filled in and sent to the address at the top. In case the form is missing, the document is also in the TIS 2000 newsletter (see icon in the TIS 2000 tool bar). At first, the user receives a temporary code until the key is registered on the next TIS 2000 CD. Hardware keys that have already been registered are still valid! To register the hardware key select ‘Hardware Key Registration’ in the menu ‘Configuration’. TIS2000 installation video guide • Start TIS 2000 on the pc. • Select the application ‘Service Programming System’ on the TIS 2000 start page. On ‘Select Diagnostic Tool and Programming Process’ (picture below) screen make the desired selection for 1) the used Tech2 diagnostic tool 2) the reprogramming of an ECU that was not exchanged or the replacement/programming of a new ECU 3) the ECU location. • Click “Next” button to continue. Step 2: Data Request • Connect Tech 2 scanner to vehicle. Power on device – “Tech 2” is displayed on the screen, then press “ENTER”. • Turn ignition to ON without start the engine!!! • Select “F1: Service Programming System (SPS)” in the main menu. • Press “F0: Request Info” on Tech 2. • If Tech 2 has already stored vehicle data they will be displayed now. In that case, Tech 2 asks you to either use the current data (hold data) or request further information from the ECU (continue). • For the selection of “Next” the vehicle has to be identified as requested by Tech 2. Note: Depending on the model year and the selected model either a reprogramming of the ECU (F0: Engine) or of the TCM (F1: Transmission) can be selected. • During the Request Info the Tech 2 receives information from the selected device. If the ECU was replaced a “Request Info” has to be performed for the NEW unit. Since the new ECU is not programmed on delivery, the retrieved information is not complete. For that reason, TIS 2000 gives instructions as how to enter the missing vehicle data. • Follow the instructions on the Tech 2. Then press “Exit” on the Tech 2, switch it off and disconnect it from the vehicle. Step 3: Data exchange • Connect Tech 2 to the pc, switch it on, and click on ‘Next’ on the pc.
0 Comments
Leave a Reply. |